Matte Plastic Paint I/E Multicolor 400

Modo de empleo :

It can be applied by brush, roller or spray.

All supports shall be clean, dry, free of grease and saltpetre.

If the surface is new, it will be applied directly, but diluting the first coat with 10-15%.

If it is very absorbent, it will be previously fixed.

If the surface is already painted and in good condition it will also be applied directly, but if not, the paint must be removed to proceed as a new surface.

Due to the matte finish, a tintometric chart with the same or similar finish to that of the product to be tinted should be used to avoid differences in the results due to gloss differences (RAL for Gloss, Jafep Standard or NCS for Matte finishes, etc.).

Presentación:

Plastic containers of: 4 Liters; 15 Liters.

Acrylic copolymers

Plastic paint suitable for interior and exterior, easy to apply, quick drying and good washability. Additive with anti-mildew preservative.

• To avoid the effect of splicing, it is better to apply wet on wet without interruption.
• In case of humid conditions, slightly shiny and sticky yellowish-transparent traces may appear on the surface of the applied substrates. These traces are of additives that are soluble in water and disappear over time after repeated heavy rainfall. The quality of the coating will not be affected by these changes (these traces do not occur if the product is applied in suitable climatic conditions).
• Surfaces with salt efflorescence are a risk for which we cannot assume responsibility (application with warranty), because even after the most thorough treatment, efflorescence can reappear.
• Do not apply at temperatures below 5 ºC or above 35 ºC.
• Do not expose containers to extreme temperatures.
• Homogenize the product well before use.

• In its original closed container, at not extreme temperature and humidity.
• Keep out of direct sunlight.
• Maximum recommended from manufacture: 2 years.